1
ASSEMBLE THE BRACKET AND BRACKET DOOR SUPPORTS WITH THE
PROVIDED BOLTS, WASHERS, AND NUTS. THE LOWER BRACKET
SUPPORTS SHOULD BE INSTALLED WITH THE LONG SLOTTED HOLES
FOR DOOR SIZE ADJUSTMENTS DEPENDING ON JEEP MODEL.
2
USING A STUD FINDER, LOCATE THE STUDS ON YOUR INSTALLATION
WALL. THE DOOR HOLDER BRACKET SHOULD BE MOUNTED AT LEAST 48”
FROM FLOOR. AS SHOWN, THE NUT RETAINERS WELDED ONTO THE
FRAME SHOULD BE POSITIONED TOWARDS THE BOTTOM.
3
POSITION/ MARK THE MOUNTING POSITION. USE THE BRACKET FOR
REFERENCE AND DRILL 1/4” PILOT HOLES IN EACH STUD CENTER. PILOT
HOLES SHOULD BE AT LEAST 2” INTO THE STUD. ASSEMBLE AND INSTALL
THE DOOR STRAP RETAINERS BY SCREWING INTO NUT RETAINERS.
WOOD STUDS
WOOD STUDS
WOOD STUDS
WOOD STUDS
WOOD STUDS
WOOD STUDS
WOOD STUDS
48.0”
HEIGHT
USE BRACKET
AS HOLE TEMPLATE
DRILL 1/4”
PILOT HOLES
MINIMUM 2”
INTO STUD
4
DETERMINE THE PROPER LENGTH 5/16” LAG BOLTS FOR YOUR APPLICA
TION. BOLTS MUST BE EMBEDDED AT LEAST 2” INTO STUD. USING 5/16”
LAG BOLTS AND 5/16” FLAT WASHERS, ATTACH THE DOOR HOLDER
BRACKET TO THE WALL. TIGHTEN THE UPPER DOOR SUPPORTS FULLY.
DETERMINE 5/16”
LAG BOLT LENGTH
FOR YOUR APPLICATION