(2) Pole-a
(1) Clamp-b
(1) Clamp Brace-c
(1) Swivel Arm-d
(2) VESA Plate-e
(3) M5X16 Bolt-f
(2) M8X12 Bolt-g
(2) Nut -h
(1) Grommet Base Plate-m
(2) Wire Clip-n1
(4) Wire Clip-n2
(1) Allen Key-o
(1) M10 Bolt-i
(1) Support Plate-j
(1) M10 Washer-k
(1) Spring Washer-l
(1) Wrench-p
(8) M4X12 Bolt-q
(8) M4X30 Bolt-r
(8) M8 Spacer-s
WARNING
CAUTION!
This monitor desktop mount must be securely
attached to the horizontal desk. If the mount is
not properly installed it may fall, resulting in
possible injury and/or damage.
Supplied Parts List
Step 1
Install the Pole to the Desktop
Step 2
Install Arm to the Pole
Option A: Desk Clamp Install
1.Install the Clamp Brace(c) to the Pole(a),
Using 3pcs M5x16 Bolts(f), and tighten
using the ALLen Key(o) , see Figure 1.
）
2.Install the Clamp(b) to the pole assembly
according to the thickness of the desktop.
The thickness can be changed of three
positions. Connect it using 2 pcs M8x12
Bolts(g), and tighten using the Allen Key(o).
Tighten with the Allen Key-o. See Figure 2
Figure 2
Option B: Grommet Base Install
Existing Grommet Hole Installation
If the existing grommet hole comes with a plastic
protector, remove it to ensure a flat surface before
installing the desk mount.
,
1. Mounting base (m)
Pole (a) is tightened with 3 M5x16 bolts (f) and an
Allen Key(o), see Figure 3.
2.Position the Pole(a) on the mounting surface
and secure using the Suport Plate(j), M10
Washer(k), Spring Washer(I), and M10 Bolt(i).
Fasten the M10 Bolt using provided
Wrench(p), see Figure 4.
Option B: Grommet Base Install
Self Drilled Grommet Hole Installation
1. Punch a 10MM hole in the table to install the lock hole.
2. Install the Grommet Base Plate(m) to the Pole(a)
using 3pcs M5x16 Bolts(f), and tighten using the
Allen Key(o), see Figure 5.
3. Position the Pole(a) on the mounting surface
and secure using the Support Plate(j).
M10 Washer(k), Spring Washer(l) and
M10 Bolt(i), Fasten the M10 Bolt using provided
Wrench(p), see Figure 6.
a
m
f
Figure 1
Figure 3
Figure 4
Figure 5
Figure 6
j
k
l
i
a
m
f
j
k
l
i
a
c
f
g
o
b
Plastic Knob
Install Swivel Arm(d) to the Pole.Fasten the bolt with supplied Allen Key(o).
Tools Required
Phillips Screwdriver
(3) M5X16 Bolt-t
d
o
n1
n2
Rotate two poles into one
Tighten the stud screws with
a wrench after tightening
Step 1
Install the Pole to the Desktop