SUPRENT HC315, User Manual, Page: 3 / 5

Step 5-The Finishing Touch
• Finally, use the Taper Lever without an attachment comb for close trimming
around the base of the neck, the sides of the neck and the ears.
• To produce a clean straight line at the sideburns, reverse the clipper by turning
the reverse side uppermost .
(See diagram 7)
• Press the clipper at right angles to the head,
tips of the blades lightly touching the skin and
work downwards. This way will obtain, as a clean
cut as would be given by a razor.
1. Unit must be off. Hold unit securely in one hand Grip blade and push with
your thumb the top of the blade away from the unit.
2. Adjust the scale at the bottom to 2.0 mm before
moving the cutter head off the retaining snaps.
3. Pull blade away from unit.
Reverse order to reattach blade.
4. Use the brush included to remove the accumulated hair from the cutters.
5. Clean the cutter head of the hair clipper with a damp cloth or under
running water.
Blades Maintenance
Blades Maintenance is recommended to oil the blades after every use.
Place 2 to 3 drops of lubricating oil on the moving blade and turn on
the clipper.
Step 4-Top of The Head
• Using the comb attachment 9mm or 12mm, cut top of head from back to front
against the direction in which the hair normally grows. In some cases, this may
require the reverse, or cutting from front to back.
(See diagram 4)
• Comb attachments 3mm or 6mm are used to achieve a close crew cut or
short cut.
• For longer hair on top, use the comb provided and lifts hair on the top of the
head. Cutover the comb, with the hair lifted or hold the hair between the fingers
to lift it and cut it to desired length. Always work from the back of the head.
Hair can be cut shorter gradually by reducing the space between the
comb/fingers, and the head.
Comb out trimmed hair and check for uneven strands.
(See diagram 5&6)
BLADE REMOVAL AND CLEANING
Short Tapered, Flat Tops and Short Cuts Hairstyle
• Starting with the longest attachment comb (12mm), cut from the back of the
neck to the crown. Hold the attachment comb flat against the head and slowly
move the clipper through the hair .
(See diagram 8)
• Use the same procedure from the lower side
to the upper side of the head. Cut the hair against
the direction in which it grows from the front to the
crown and then level the cut with the sides.
• To give a 'flat top' look, the hair on top of the head must
be cutover the top of a flat comb instead of using the
attachment comb.
• Use closer cutting attachment combs to taper the hair
down to the neckline as desired.Comb hair and check for
uneven areas and outlining sideboards and neckline as
described previously.