Planning
We suggest that one hand dryer be installed for every two
hand basins.
The BA404, BA405, BA406 AND BA407 hand dryer
should NOT be installed over bench tops or reflective
surfaces.
When positioning dryers take note of traffic flows in the
washroom, also be aware of obstructing doors, cabinets
etc.
Electrical Connection
Installation must be carried out by a qualified person in
accordance with all local wiring regulations.
Fixed wiring is recommended for all installations. Wiring
should emerge from the wall in the position marked on the
mounting diagram.
A fixed wiring should incorporate a switch or breaker with
a contact separation of at least 3mm in all poles.
Installation may be permitted in area 2 and 3 due to class
II and IP23 rating as long as the whole electrical circuit is
protected by an earth leakage breaker with a maximum
sensitivity of 30ma.
Installation Instructions
NOTE: Dryer should not be installed within 500mm of
a bench top or reflective surface.
1.Remove cover by firstly loosening the two screws at top
of cover using allen key supplied.
2. Pull top of cover away from back plate and push down
and out to remove.
3. Pass power supply cable through hole in back plate.
4. Position back plate on wall as per mounting diagram
and securely fasten.
5. After terminating cable replace the cover and test
operation.
6. The sensor sensitivity should be adjusted as
required by turning the trim pot at base of machine.
Turning anti-clockwise to increase sensitivity
(range), clockwise to decrease (less range).
Maintenance Instructions
Very little maintenance is required to keep your hand
dryer in first class operating order. However, the
following maintenance should be carried out six
monthly in high traffic areas and twelve monthly in
normal traffic areas.
1. Disconnect power supply and remove cover
2. Carefully clean lint from inside the dryer
3. Wash cover in warm soapy water to remove grime
Your guarantee could become void if the above is not
performed at the specified intervals.
NOTE: If the power cord of this appliance is damaged,
it must only be replaced by a repair shop appointed by
the manufacturer, or a suitably qualified person in
order to avoid a hazard.
Service Hints
All service work should be carried out by a qualified
trades person. Turn off power supply before removing
the cover. In event of your hand dryer failing to start,
firstly check that the power is available, the sensor
lenses are clean and sensor sensitivity has been
adjusted.
Safety Precautions &
Standards Compliance
Supreme Hand Dryers have been tested and comply
with all relevant Australian and New Zealand standards
for electrical safety and electromagnetic interference.
CAUTION
•
The dryer is not intended for use by young children or
infirm persons without supervision.
•
Young children should be supervised to ensure that
they do not play with the appliance.
•
Do not insert objects into the air outlet, doing so can
be hazardous and could result in electric shock.
•
Do not obstruct the air inlets or outlets in any way.
•
Do service your Hand Dryer at regular
intervals.
135m
mounting holes 6mm
cable entry
250mm
245mm
65mm
120mm
Height recommendations
Recommended height to bottom of dryer.
Men’s washroom
1100mm
Ladies’ washroom
1050mm
Children’s washroom
13-17yrs
1000mm
Children’s washroom
10-13yrs
950mm
Children’s washroom
7-10yrs
900mm
Children’s washroom
4-7yrs
800mm
Disabled Person’s
800mm
