5
WARNING
CAUTION
Turn controls and gas source or tank OFF when
not in use.
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
burner and could accidently ignite with risk of injury.
Safety Tips
• When Griddle is not in use, turn the Griddle off.
• Never move
Griddle while in operation or
still hot.
• Use long-handled barbecue utensils and oven mitts to
avoid burns and splatters.
• Keep unit at least 36” away from walls, buildings,
vehicles or other structures when in use.
• Clean
G
riddle often, preferably after each
cookout.
• If you notice grease or other hot material dripping from
g
riddle onto the valve or regulator, turn off gas
supply
at once. Determine the cause, correct it, then
clean
and inspect valve, hose and regulator before
continuing. Perform a leak test.
• Keep ventilation openings in cylinder enclosure free
and clear of debris.
• The regulator may make a humming or whistling noise
during operation. This will not affect safety or use of
g
riddle.
• If you have a problem with your
griddle
refer to the
Troubleshooting Section o
r
customer support at
657-341-0362 or
email [email protected]
• If the regulator frosts, turn off
Griddle
and LP bottle
valve immediately. This in-dicates a problem with the
LP bottle and it should not
be used on any product.
Return to supplier.
USE AND CARE
Burner Flame Check
Light burner, rotate knob from high to low. You should see
section on page 10.
Turn knob to the OFF position.
Valve Check
Important:
knob should spring back. If knob does not spring back,
replace valve assembly before using the 17” Griddle. Turn
knob to low position then turn back to OFF position.
Valve should turn smoothly.
General Griddle Cleaning
•
Do not mistake brown or black accumulation of grease
and smoke for paint. Do not apply a caustic griddle/
oven cleaner to painted surfaces.
•
Plastic parts: Wash with warm soapy water and
wipe dry. Do not use Citrisol, abrasive cleaners, de-
greasers or a concentrated oven cleaner on plastic
parts. Damage to and failure of parts can result.
•
Painted surfaces: Wash with mild detergent or
nonabrasive cleaner and warm soapy water. Wipe dry
with a soft nonabrasive cloth.
•
Baked-on grease deposits may require the use of an
abrasive plastic cleaning pad. Use only in direction of
pad on areas with graphics.
Turning Griddle OFF
