3
cloth to wipe it. Benzene and banana water etc. should not be used for cleaning, which it may lead
to discoloration or deformation.
●Please do not make the live parts approach the signal terminal, which may cause fault.
●Please do not impact this instrument.
●If you confirm that smoke, undesirable odor, abnormal noise and other abnormal situations
occur from the instrument, please cut off the power supply immediately and contact the supplier or
our company in time.
●In order to ensure the normal work of instrument measurement, please energize the thermal
machine for 30 minutes prior to using the instrument.
3.1.2 Precautions for using external storage media
●Storage media is a sophisticated product. Please use it carefully.
●In addition to inserting and removing storage media, please close the operation cover when
running. Storage media and USB interface should reduce contact with dust for protection.
●Pay attention to electrostatic protection when using Flash and SD card.
●Recommend the use of our products.
●When using storage media at high temperature (about above 40
℃
), please insert the storage
media when saving the data. After the data is saved, remove it and keep it. Do not keep inserting it
into the instrument for a long time.
●Before you switch on or switch off the power, please remove the storage media.
●For general precautions for use of storage media, please refer to the instructions carried for
use of the storage media.
3.2 Installation of instrument
3.2.1 Sites of installation
Please install the following sites:
●Installation disk
This instrument is disk-installed.
●Place for installation
It should be installed indoors, where it can avoid rain and direct sun.
●Well ventilated places.
In order to prevent the temperature rise in the internal of this instrument, please install it in a
well ventilated place.
●Places with less mechanical vibration.
Please choose a place with less mechanical vibration.
●Flat place
When installing this instrument, do not incline to the left or right, as flat as possible, with an
allowable maximum backward inclination of 30°).
———————————————————————————————————————
★
Move the instrument from the place with low temperature and humidity to the place with
