Superwind 350 12V, Manual

Page: 32 / 79

V 01-2017
www.superwind.com
31
Insert the yaw shaft of the
Superwind
with the plastic bushing to the limit stop
(collar), and align the tap holes with the drilled holes of the mast. Screw down the
two hexagon socket button head screws (M6 x 12) for axial fixation. The screws
now extend into the groove of the yaw shaft, but will not touch it.
Next, screw in the two hexagon socket button head screws (M6 x 6) provided for
the axial fixation of the bushing in the mast head. The screws now extend into the
groove of the yaw shaft, but will not touch it. This entire assembly, when installed
correctly, provides sound and vibration dampening.
7.3
Mounting of the wind vane
The wind vane is fastened to the rear cover of the generator. Insert the wind vane and the
mounting plate into the groove. As viewed from the rear (Graphic No. 7.3), the mounting
sheet must be on the right side. Next, insert the two socket cap screws M8 x 20 and
screw them down firmly.