1: Install Front Steering Axle Assembly:
Turn car upside down. Insert steering rod, into the steering motor
located in the center on the car, towards the front. Make sure
steering rod is aligned with the motor, and coming out the
dashboard. Place the steering axle assembly with the motors into
place on the body of the car (as shown in the photo). Secure into
place with 4 screw per side.
2: Installation of the wheels, wheel covers & front bumper:
Place front bumper into place as shown in picture. Secure with 4
screws on each side. Remove lug nut and washer from each side of
axle. Slide wheel into place, and make sure to align hub adaptor to
motor. Slide washer, then nut back on and tighten down with wheel
nut wrenches. Do not over tighten tires because this could cause
premature motor failure. Repeat process for back wheel assembly.
Place wheel covers on with 3- screws each on all 4 wheels.
