5-10
SUPERSERVER
6027R-TRF USER'S MANUAL
5-5 Installing
Memory
Figure 5-3. Installing DIMM into Slot
!
CAUTION! Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
Memory Support
The X9DRi-F supports up to 512 GB of DDR3 1600/1333/1066/800 MHz speed
registered ECC 1GB, 2GB, 4GB, 8GB, 16GB and 32GB size SDRAM in
sixteen (16) DIMM slots. See the following table for memory installation.
Memory speed support is dependent on the type of CPU used on the board.
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots, starting with
DIMM 1A. For best memory performance, please install memory modules
of the same type and same speed on the memory slots as indicated on the
tables below.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
To I n s t a l l :
I n s e r t
module vertically and
press down until it
snaps into place. Pay
attention to the align-
ment notch at the
bottom.
To R e m o v e :
U s e
your thumbs to gen-
tly push the release
tabs near both ends
of the module. This
should release it from
the slot.
Top View of DDR3 Slot
Release Tab
Release Tab
Note:
Notch should align with
the receptive key point on
the slot.
Notch
Notch
Front View
Summary of Contents for SUPERSERVER 6027R-TRF
