Supero SuperServer 5016I-MT, User Manual

Page: 51 / 102

Chapter 5: Advanced Motherboard Setup
5-17
Fan Headers
The X8SIE/X8SIE-F has five fan
headers, all of which are 4-pin fans.
However, pins 1-3 of the fan headers
are backward compatible with the
traditional 3-pin fans. See the table
on the right for pin defi nitions. Fan 1
is intended for use with the CPU. A
fan speed control setting in the BIOS
Hardware Monitoring section allows
the BIOS to automatically set fan
speeds based on the system tempera-
ture. The default setting is Disabled
which allows the onboard fans to run
at full speed. Refer to the table on the
right for pin defi nitions.
ATX PS/2 Keyboard and PS/2
Mouse Ports
The ATX PS/2 keyboard and the PS/2
mouse are located on the I/O back-
panel. The mouse port is above the
keyboard port. See the table on the
right for pin defi nitions.
Fan Header
Pin Defi nitions
Pin# Defi nition
1 Ground (Black)
2 2.5A/+16V (Red)
3 Tachometer
4 PWM Control
PS/2 Keyboard and
Mouse Port Pin
Defi nitions
Pin# Defi nition
1 Data
2 NC
3 Ground
4 VCC
5 Clock
6 NC
Chassis Intrusion
The Chassis Intrusion header is des-
ignated JL1. Attach an appropriate
cable from the chassis to inform you
of a chassis intrusion when the chas-
sis is opened
Chassis Intrusion
Pin Defi nitions
Pin# Defi nition
1 Intrusion Input
2 Ground
Note : Please use all 3-pin fans or all 4-pin fans
on a motherboard. Please do not use 3-pin fans
and 4-pin fans on the same board.
Speaker
On the JD1 header, pins 3~4 are used
for internal speaker. Close pins 3~4
with a cap to use the onboard speaker.
If you wish to use an external speaker,
close pins 1~4 with a cable. See the
table on the right for pin defi nitions.
Speaker Connector
Pin Defi nitions
Pin Setting Defi nition
Pins 3~4 Internal Speaker
Pins1~4 External Speaker