Supero SuperServer 5015M-MT, User Manual

Page: 55 / 118

Chapter 5: Advanced Motherboard Setup
5-21
5-12 Parallel Port and Peripheral Drive Connections
Use the following information to connect the IDE hard disk drive cables.
• A red mark on a wire typically designates the location of pin 1.
• The 80-wire ATA100/66 IDE hard disk drive cable that came with your system
has two connectors to support two drives. This special cable should be used
to take advantage of the speed this new technology offers. The blue connector
connects to the onboard IDE connector interface and the other connector(s) to
your hard drive(s). Consult the documentation that came with your disk drive
for details on actual jumper locations and settings for the hard disk drive.
Parallel Port Connector
The parallel port is a header on
the motherboard near PCI slot.
See the table at right for pin
defi nitions.
Parallel (Printer) Port Connector
Pin Defi nitions (J30)
Pin# Defi nition Pin # Defi nition
1 Strobe- 2 Auto Feed-
3 Data Bit 0 4 Error-
5 Data Bit 1 6 Init-
7 Data Bit 2 8 SLCT IN-
9 Data Bit 3 10 GND
11 Data Bit 4 12 GND
13 Data Bit 5 14 GND
15 Data Bit 6 16 GND
17 Data Bit 7 18 GND
19 ACK 20 GND
21 BUSY 22 Write Data
23 PE 24 Write Gate
25 SLCT 26 NC
IPMI Socket
The IPMI 2.0 socket on the
serverboard is included for
the use of an IPMI (Intelligent
Management Platform Inter-
face) card.