Supero SUPERO SUPERSERVER SYS-6026T-6RFplus, User Manual

Page: 64 / 110

6-2
S
UPER
S
ERVER SYS-6026T-6RFT+/SYS-6026T-6RF+ User's Manual
Figure 6-1. Chassis: Front and Rear Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
6-3 System Fans
The SC829 chassis contains four 8-cm high-performance fans. The SC119 chassis
provides two additional open fan housings, where an additional system fan may be
added for optimal cooling.
Control Panel
Hard Drive Bays (8)
Fixed Hard Drive Bays (3)
PCI Expansion Slots (w/riser cards)
Mouse/Keyboard Ports COM Port VGA Port Gb Ports 10 Gb Ports*
USB Ports Dedicated IPMI LAN Port Power Supplies
*SYS-6026T-6RFT+ only.