Supero SUPERO SuperServer 6026TT-GIBQRF, User Manual

Page: 10 / 104

1-2
SUPERSERVER 6026TT-GTRF/GIBXRF/GIBQRF User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 6026TT are four X8DTT-HF+/X8DTT-HIBXF+/
X8DTT-HIBQF+ dual processor serverboards. The X8DTT-HF+ is based on Intel's
5500 (North Bridge) + ICH10R (South Bridge) chipset while the X8DTT-HIBXF+/
X8DTT-HIBQF+ is based on Intel's 5520 (North Bridge) + ICH10R (South Bridge)
chipset. Below are the main features of the serverboards. Note that the features on
each board are doubled for the server, which includes two nodes.
Processors
Each X8DTT-HF+/X8DTT-HIBXF+/X8DTT-HIBQF+ supports two Intel® 5600/5500
Series processors in LGA1366 sockets. Please refer to our web site for a complete
listing of supported processors (www.supermicro.com).
Memory
Each X8DTT-HF+/X8DTT-HIBXF+/X8DTT-HIBQF+ has twelve DIMM sockets that
can support up to 192 GB of registered ECC DDR3-1333/1066/800 SDRAM, or
48 GB of Unbuffered ECC/Non-ECC 1333/1066/800 MHz memory. See Chapter 5
Section 6 for more details on installing memory into the system.
Serial ATA
The South Bridge (ICH10R) of the chipset includes a Serial ATA controller for six
Gb/s SATA drives. The hot-swappable SATA drives are connected to a backplane
that provides power, bus termination and confi guration settings. RAID 0, 1, 10 and
5 are supported. Refer to the support area of our web site for procedures on set-
ting up RAID on your system.
PCI Expansion Slots
Each X8DTT-HF+/X8DTT-HIBXF+/X8DTT-HIBQF+ has included riser cards that
allow it to support one full-sized PCI Express x16 expansion card, or two total for
the server. (Double-width GPU cards are also supported.)
Ethernet Ports
An Intel® network controller is integrated into each of the serverboards to support
two Gigabit LAN ports (100/1000Base-T/1000BaseTX, RJ45 output).