Chapter 2: Server Installation
2-7
2-5 Checking the Serverboard Setup
After you install the 937R-E2JB in the rack, you will need to open the unit to
make sure the serverboard is properly installed and all the connections have been
made.
Accessing the Inside of the System (Figure 2-4)
Remove the two screws that secure the top cover of the chassis.
1.
Slide the cover toward the rear of the chassis and lift the cover off the unit.
2.
Make sure all power and data cables are properly connected and not blocking
3.
the chassis airfl ow. Also make sure that no cables are positioned in front of
the fans. See Chapter 5 for details on cable connections.
!
Warning:
Except for short periods of time, do NOT operate the server
without the cover in place. The chassis cover must be in place to allow
proper airfl ow and prevent overheating.
Figure 2-4. Accessing the Inside of the System
1
1
1
2
1
1
