Supero AS-4041M-82R, User Manual

Page: 55 / 106

Chapter 5: Advanced Serverboard Setup
5-21
SCSI Controller Enable/
Disable (H8QM8-2 only)
Jumper JPA1 is used to enable or dis-
able the Adaptec AIC-7902W SCSI
controller. The default setting is on pins
1-2 to enable SCSI. See the table on
right for jumper settings.
SCSI Enable/Disable
Jumper Settings (JPA1)
Both Jumpers Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SCSI Termination Enable/
Disable (H8QM8-2 only)
Jumpers JPA2 and JPA3 are used to
enable or disable termination for SCSI
channels A and B, respectively. The
default setting is open to enable termi-
nation. See the table on right for jump-
er settings.
Note: In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.)
SCSI Term. Enable/Disable
Jumper Settings (JPA2/JPA3)
Jumper Setting Defi nition
Open Enabled
Closed Disabled
Compact Flash Master/Slave
The JP1 jumper allows you to assign ei-
ther master or slave status to a compact
fl ash card installed in the IDE#1 slot.
You will need to connect compact fl ash
power to JWF1 to use. See the table
on the right for jumper settings.
Compact Flash
Master/Slave
Jumper Settings (JP1)
Jumper Setting Defi nition
Closed Master
Open Slave