Supero 2022TC-BIBQRF, User Manual

Page: 89 / 121

Chapter 6: Advanced Chassis Setup
6-11
Figure 6-12. Adapter Card Installation
Serverboard
Drawer
Adapter Card
Spacer Plate
Five Screws
6-7 Adapter Card Replacement
Each serverboard drawer comes with an adapter card which plugs into the
backplane. In the unlikely event that the adapter card must be replaced, installation
requires only a Phillips head screwdriver.
Removing the Adapter Card (Figure 6-12)
1. Disconnect the wiring connecting the adapter card to the serverboard.
2. Remove the serverboard drawer from the chassis.
3. Remove the serverboard from the drawer by removing the screws securing it
to the drawer. Set the screws aside for later use.
4. Remove the five screws securing the adapter card and the spacer plate to the
drawer and set them aside for later use.
5. Remove the adapter card and spacer plate from the serverboard drawer.
6. Set the spacer plate aside for later use.
Installing the Adapter Card (Figure 6-12)
1. Make sure the serverboard has been installed properly in the node drawer
before installing the adapter card.
2. Place the adapter card and spacer plate on the serverboard drawer, aligning
the holes in the spacer and the adapter card with the holes in the serverboard
drawer.
3. Secure the adapter card and spacer plate to the serverboard drawer, using
the five screws which were previously set aside.
4. Reconnect the wiring from the serverboard to the adapter card.
5. Return the serverboard drawer to the closed position in the chassis.