Supero 1026T-6RF+, User Manual

Page: 23 / 108

Chapter 2: Server Installation
2-9
Push the cover away from you (toward the rear of the chassis) until it stops. 3.
You can then lift the top cover from the chassis to gain full access to the
inside of the server.
To remove the system from the rack completely, press the locking tabs in 4.
the chassis rails (push the right-side tab down and the left-side tab up) to
continue to pull the system out past the locked position.
Checking the Components
You may have one or two processors already installed in the serverboard. 1.
Each processor needs its own heatsink. See Chapter 5 for instructions on
processor and heatsink installation.
Your server system may have come with system memory already installed. 2.
Make sure all DIMMs are fully seated in their slots. For details on adding
system memory, refer to Chapter 5.
If desired, you can install an add-on card to the system. See Chapter 5 for 3.
details on installing PCI add-on cards.
Make sure all power and data cables are properly connected and not blocking 4.
the chassis airfl ow. See Chapter 5 for details on cable connections.
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the hard drives and
backplane have been properly installed and all connections have been made.
Checking the Drives
All drives are accessable from the front of the server. The hard disk drives 1.
can be installed and removed from the front of the chassis without removing
the top chassis cover.
A slim DVD-ROM drive should be preinstalled in your server. For servicing 2.
the DVD-ROM drive, you will need to remove the top chassis cover. Refer to
Chapter 6 if you need to reinstall a DVD-ROM drive to the system.
Depending upon your system's confi guration, your system may have one or 3.
more drives already installed. If you need to install hard drives, please refer to
Chapter 6.