5
When you press the R key on the parent unit you disable all coding for three
seconds. This enables you to listen to the channel if there is any traffic on it.
Alarm tones can be heard under the following circumstances:
From the Baby Unit:
The battery is discharged
weak beep every 5-10 seconds
(the battery symbol blinks)
(also signalled by the parent unit)
From the Parent Unit:
The battery is discharged
every 5-10 seconds
(the battery symbol blinks)
Parent unit out of range or baby unit not every 5-10 seconds
switched on, or different channels
(the range symbol blinks).
• Both units may be used while being charged.
• Connect the chargers to the wall outlet using the adapters provided. Only
these adapters must be used.
• Place the baby unit and the parent unit in the chargers; the batteries will then
be charged.
The light indicator on the charger lights red during charging and switches to
green when the batteries are at full voltage (after around 4-6 hours), but they
should remain in the charger for a few hours more to get a full charge.
When the green light is on, the charger has gone into maintenance charging
mode. The batteries therefore will not be damaged, even if they remain in the
charger for a long time.
• The batteries may be recharged up to 500 times as long as they are used
properly, see Quick start, Item 5.
Note:
Rechargeable batteries are consumable articles that gradually decline
as they are used. Extra batteries may be purchased from your dealer. Read
the troubleshooting chart if you have any problems.
•
Two sets of environmentally friendly battery packs 3.6 V NiMH 550 mAh
•
Transmission frequency: Two channels in the 40.665 – 40.695 MHz range.
•
Working temperature: +5
O
C to +40
O
C. Storage temperature: -20
O
C to +40
O
C.
•
Output power Baby Unit < 10 mW
The authorities have only allocated a restricted number of frequencies for baby
monitors and a very limited output power. There may therefore be disturbances
from other baby monitors while your baby unit has been activated by sounds
from your baby (traffic interference). This can often be recognized as crackling
and/or beeping in the speaker. If this happens, try to switch channels and
adjust the baby unit to low sensitivity to avoid it being activated by movements
or weak sounds from the baby.
Technical specifications
(we reserve the right to make changes)
General
Using the chargers and batteries
Summary of Contents for FD-D3
Page 1: ...Baby Unit Parent Unit ...
