Chapter 1: Introduction
1-5
Jumper
Description
Default
Setting
J27, J28
I
2
C Bus to PCI-X/PCI-E Slots
Open
(Disabled)
J3P
3rd PWR Failure Detect
Off (Disabled)
JBT1
CMOS Clear
(See Chapter 2)
JCF1
Compact Card Master/Slave Select
On (Master)
JPA1 (*X7DB8+) SCSI Controller Enable
Pins 1-2 (Enabled)
JPA2, JPA3
SCSI CHA(JPA2),CHB(JPA3)Term.En Off (Enabled) (*X7DB8+)
JPG1
VGA
Enable
Pins
1-2
(Enabled)
JPL1/ JPL2
GLAN1/GLAN2 Enable
Pins 1-2 (Enabled)
JWD
Watch Dog
Pins 1-2 (Reset)
Connector
Description
ATX PWR (JPW1)
Primary 24-Pin ATX PWR Connector
Aux. PWR/CPU PWR
+12V 4-pin PWR (JWP2)/+12V 8-pin PWR(JPW3)
Alarm Reset (JAR)
Alarm Buzzer Reset
Compact Flash PW(JWF1) Compact Card PWR Connector (*Used if JFC1 is on.)
COM1/COM2
COM1/COM2 Serial Port Connectors
Chassis Intru. (JL1)
Chassis Intrusion Header
DA1/DA2
SCSI Activity LED Indicators (See Chapter 2)
DIMM#1A-DIMM#4D
Memory DDRII Slots (*See Section 2-3 in Chapter 2)
FAN 1-8
Fans 1-8 (3-pin: Fans1-4, 4-pin: Fans5-8, Fans7/8:
CPU
Fans)
FP CTRL (JF1)
Front Control Panel Connector
Floppy (J22)
Floppy Disk Drive Connector
GLAN 1/2 (JLAN1/2)
G-bit Ethernet Ports
IDE1/IDE2 (*Note)
IDE1 Hard Drive (JIDE1)/Compact Flash Card (JIDE2)
Keylock (JK1)
Keylock Header
OH LED (JOH1)
Overheat LED
Parallel Port (J21)
Parallel (Printer) Port
PWR LED/Speaker (JD1) PWR LED(pins1-3)/Speaker Header (pins 4-7)
PWR LED (LE1)
PWR LED Indicator (*Note6 on Pg.1-4)
PWR SMB (J17)
Power System Management (I
2
C) Header
PSF (JP3)
Power Fault (Power Supply Failure: See Chapter 2)
SATA0-SATA5
Intel SATA 0-5 Connectors
SCSI Chan.A/B(JA1/JA2) SCSI Channel A & B Connectors (*X7DB8+ only)
SGPIO 1/2
Serial General Purpose Input/Output Headers
SIMLP IPMI (Slot 7)
SIM Low Profi le IPMI Connector
SMB (J18)
System Management Bus Header
USB 0/1,USB 2/3, USB4 Back Panel USB 0/1, Front Panel USB 2/3, FP USB4
VGA (J15)
VGA Connector
WOL (JWOL)
Wake-on-LAN Header
WOR (JWOR)
Wake-on-Ring Header
*Note: JIDE2 is for Compact Card Use only. For Compact Card to work properly,
please enable JCF1 by putting a jumper on it and connect JWF1 to a power
supply.
Quick Reference ( X7DB8+/X7DBE+)
