31
Chapter 2: Installation
CPU
LED2
KVM
IPMI_LAN
JPG1
SW1
JUIDB1
LED1
JI2C2
JI2C1
JIPMB1
JMD4
JP2
JPME2
JPME1
JWD1
JTPM1
USB2 (3.0)
JMD3
JMD2
JMD1
JBT1
J5
S-SGPIO1
BT1
S-SA
TA/SAS0
S-SA
TA/SAS1
X10SDD-F
Rev. 1.01
LEDM1
BAR
CODE
MA
C
CODE
BMC
JPCIE1
MICRO-LP
JPCIE2
DIMMB2
DIMMB1
DIMMA2
DIMMA1
SATA and SAS Ports
Two Serial ATA (SATA)/Serial Attached SCSI (SAS) 3.0 connectors (I-SATA0/SAS0, I-SATA1/
SAS1) are located on the motherboard. These connectors are for add-on card (storage card)
use.
Your system will have two hard drives connected through the backplane of the motherboard.
The default setting for the SATA/SAS connectors is for SATA drives, as controlled by the
Intel Intel® Xeon® D, Pentium SoC. For SAS drives, an additional SAS storage card must
be connected to the riser card on JPCIE2 and a cable must be connected from the storage
card to the SATA/SAS connectors.
See the table below for pin definitions.
Note
: Please remember to close the appropriate pins on the J5 jumper.
1
2
1. I-SATA0/SAS0
2. I-SATA1/SAS1
SATA 3.0 Port
Pin Definitions
Pin#
Signal
1
Ground
2
SATA_TXP
3
SATA_TXN
4
Ground
5
SATA_RXN
6
SATA_RXP
7
Ground
