Supermicro SuperServer 8028B-C0R3FT, User Manual

Page: 77 / 142

Chapter 5: Advanced Serverboard Setup
5-27
I
2
C for PCI-E slots
Jumper Settings
Jumper Setting Definition
Off Normal (Default)
On Enabled
ME Mode Select
Jumper Settings
Jumper Setting Definition
Pin 1-2 Normal (Default)
Pin 2-3 Manufacture Mode
SAS Enable (for X10QBL-CT only)
Use Jumper JPS1 to enable or disable
onboard SAS connections (L-SAS 0-3,
4-7) on the X10QBL-CT. The default
setting is on pins 1/2 to enable SAS
support. See the table on the right for
jumper settings.
SAS Enable
Jumper Settings
Jumper Setting Definition
Pin 1-2 Enabled (Default)
Pin 2-3 Disabled
TPM Support Enable
JPT1 allows the user to enable TPM
(Trusted Platform Modules) support
to enhance data integrity and system
security. See the table on the right for
jumper settings. The default setting is
enabled.
TPM Enable
Jumper Settings
Jumper Setting Definition
Pin 1-2 Enabled (Default)
Pin 2-3 Disabled
I
2
C Bus to PCI-Exp. Slots
Use Jumpers JI
2
C1 and JI
2
C2 to
connect the System Management
Bus (I
2
C) to the PCI-Express slots to
improve PCI performance. These two
jumpers are to be set at the same time.
The default setting is off to disable
the connection for normal operations.
See the table on the right for jumper
settings.
Manufacturer Mode Select
Close pin 2 and pin 3 of Jumper
JPME2 to bypass SPI flash security
and force the system to operate in the
Manufacturer mode, which will allow
the user to flash the system firmware
from a host server for system setting
modifications. See the table on the
right for jumper settings.