Supermicro SUPERSERVER 6022P-6, User Manual

Page: 52 / 106

5-18
S
UPERSERVER 6022P-6 User’s Manual
LAN1 Enable/Disable
Change the setting of jumper JP3
to enable or disable the onboard
LAN1 or NIC (Network Interface
Card) on the motherboard. See
the table on the right for jumper
settings. The default setting is
pins 1-2.
Ju m p e r
P o sitio n
P in s 1 -2
P in s 2 -3
D e fin itio n
E n a b le d
D isa b le d
L A N 1 (N IC )
E n a b le /D is a b le
J u m p e r S e tting s
(J P 3 )
LAN2 Enable/Disable
Change the setting of jumper JP27
to enable or disable the onboard
LAN2 or NIC (Network Interface
Card) on the motherboard. See
the table on the right for jumper
settings. The default setting is
pins 1-2.
Ju m p e r
P o sitio n
P in s 1 -2
P in s 2 -3
D e fin itio n
E n a b le d
D isa b le d
L A N 2 (N IC )
E n a b le /D is a b le
J u m p e r S e tting s
(J P 2 7 )
VGA Enable/Disable
JP4 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
S e e t h e t a b l e o n t h e r i g h t f o r
jumper settings.
Ju m p e r
P o sitio n
1 -2
2 -3
D e fin itio n
E n a b le d
D isa b le d
V G A E n a b le /D is a b le
J u m p e r S e tting s
(J P 4 )
Power Supply Alarm
Enable/Disable
The system will notify you in the
event of a power supply failure.
This feature assumes that three
power supply units are installed in
the chassis, with one acting as a
backup. If you only have one or
two power supply units installed,
you should disable this (the default
setting) with JP9 to prevent false
alarms. See the table on the right
for jumper settings.
Ju m p e r
P o sitio n
O p e n
C lo se d
D e fin itio n
D isa b le d
E n a b le d
P o w e r S u p p ly
A la rm E n a b le /D is a b le
J u m p e r S e ttin g s (J P 9 )