Supermicro SUPERSERVER 6014L-M4, User Manual

Page: 26 / 122

2-8
S
UPER
S
ERVER 6014L-M4 User's Manual
2-5 Checking the Motherboard Setup
After you install the 6014L-M4 in the rack, you will need to open the unit to make sure
the motherboard is properly installed and all the connections have been made.
1. Accessing the inside of the system (Figure 2-4)
First, grasp the two handles on either side and pull the unit straight out until it locks
(you will hear a "click"). Next, depress the two buttons on the top of the chassis to
release the top cover. There is a large rectangular recess in the middle front of the
top cover to help you push the cover away from you until it stops. You can then lift
the top cover from the chassis to gain full access to the inside of the server.
2. Check the CPUs (processors)
You may have one or two processors already installed into the system board. Each
processor should have its own heatsink attached. See Chapter 5 for instructions
on processor installation.
3. Check the system memory
Your 6014L-M4 server system may have come with system memory already in-
stalled. Make sure all DIMMs are fully seated in their slots. For details on adding
system memory, refer to Chapter 5.
4. Installing add-on cards
If desired, you can install an add-on card to the system. See Chapter 5 for details
on installing a PCI add-on card.
5. Check all cable connections and airfl ow
Make sure all power and data cables are properly connected and not blocking the
airfl ow. See Chapter 5 for details on cable connections. Also, check the air seals
for damage. The air seals are located under the chassis fans and beneath the
frame cross section that separates the drive bay area from the motherboard area
of the chassis.