Supermicro SUPERSERVER 1028R-MCTR, User Manual, Page: 7 / 75

1-2 1-3
Chapter 1: Introduction
S
UPER
S
ERVER 1028R-MCT/MCTR User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 1028R-MCT/MCTR lies the X10DRL-CT, a dual
processor serverboard based on Intel's PCH C612 chipset. Below are the main
features of the X10DRL-CT (see Figure 1-1 for a block diagram of the chipset).
Processors
The X10DRL-CT supports up to two Intel ® Xeon ® E5-2600 v3/v4 Series processors
in R3 LGA 2011 sockets. Please refer to the serverboard description pages on our
website for a complete listing of supported processors.
Memory
The X10DRL-CT has eight DIMM sockets that can support up to 1 TB of ECC
LRDIMM (Load Reduced Load DIMMs) or 512 GB of RDIMM (Registered DIMMs)
DDR4-2400/2133/1866/1600 memory. Please refer to Chapter 5 for installing
memory.
SAS
Eight SAS 3.0 ports are supported by the onboard LSI 3108 controller. RAID 0, 1,
5, 6 and 10 supported.
SATA
An on-chip SATA controller is integrated into the X10DRL-CT to provide six SATA
3.0 ports, which are RAID 0, 1, 5 and 10 supported.
PCI Expansion Slots
A riser card (RSC-RR1U-E8) has been pre-installed to the X10DRL-CT to support
one full-height, half-length PCI-E 3.0 x8 PCI expansion card.
I/O Ports
The rear I/O ports include one VGA port, two USB 3.0 ports, two 1 Gb LAN ports,
two 10 Gb LAN ports and a dedicated IPMI LAN port.
1-3 Server Chassis Features
The SC113MFAC2-605CB/SC113MFAC2-R606CB is a short depth (< 20") 1U
chassis that features eight 2.5" hard drive bays. The following is a general outline
of the main features of the SC113MFAC2-605CB/SC113MFAC2-R606CB chassis.
System Power
When configured as the SuperServer 1028R-MCT/MCTR, the SC113MFAC2-605CB
includes a single high-efficiency 600W power supply and the SC113MFAC2-
R606CB includes redundant, 600W hot-plug high-efficiency power supplies.
Control Panel
The control panel on the SC113MFAC2-605CB/SC113MFAC2-R606CB provides
important system monitoring and control information. LEDs indicate power on,
network activity and hard disk drive activity. Also present are a main power button
and a system reset button.
Cooling System
The chassis' revolutionary cooling design has been optimized to provide sufficient
cooling for dual CPU configurations. The chassis includes four 4-cm counter-
rotating, PWM (Pulse Width Modulated) fans located in the middle of the chassis.
Fan speed is controlled via IPMI.