Supermicro Supero 6016T-6F, User Manual

Page: 68 / 122

5-20
S
UPER
S
ERVER 6016T-6F User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
I
2
C to PCI-E Slots
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
I
2
C Bus to PCI-Exp. Slots
Jumpers JI 2 C1 and JI 2 C2 allow you to
connect the System Management Bus
(I 2 C) to the PCI-Express slots. The de-
fault setting is pins 2-3 (Disabled.) Both
jumpers must be set to the same setting
See the table on the right for jumper
settings.
Watch Dog Enable/Disable
Jumper JWD controls the Watch Dog
function. Watch Dog is a system moni-
tor that can reboot the system when a
software application hangs. Jumping
pins 1-2 will cause WD to reset the
system if an application hangs. Jumping
pins 2-3 will generate a non-maskable
interrupt signal for the application that
hangs. See the table on the right for
jumper settings. Watch Dog must also
be enabled in BIOS.
Note: When enabled, the user needs to
write their own application software in
order to disable the Watch Dog Timer.
Watch Dog
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
SAS Enable/Disable
Jumper JPS1 allows you to enable or
disable the onboard SAS connections.
The default setting is pins 1-2 to enable
the connection. See the table on the
right for jumper settings.
SAS Enable/Disbale
Jumper Settings
Jumper Setting Defi nition
1-2 SAS Enabled
2-3 SAS Disabled