Chapter 20: System Management Commands
Line
– 683 –
E
XAMPLE
Console(config-line)#password 0 secret
Console(config-line)#
R
ELATED
C
OMMANDS
password-thresh
This command sets the password intrusion threshold which limits the
number of failed logon attempts. Use the
no
form to remove the threshold
value.
S
YNTAX
password-thresh
[
threshold
]
no password-thresh
threshold
- The number of allowed password attempts.
(Range: 1-120; 0: no threshold)
D
EFAULT
S
ETTING
The default value is three attempts.
C
OMMAND
M
ODE
Line Configuration
C
OMMAND
U
SAGE
When the logon attempt threshold is reached, the system interface
becomes silent for a specified amount of time before allowing the next
logon attempt. (Use the
command to set this interval.) When
this threshold is reached for Telnet, the Telnet logon interface shuts down.
E
XAMPLE
To set the password threshold to five attempts, enter this command:
Console(config-line)#password-thresh 5
Console(config-line)#
R
ELATED
C
OMMANDS
silent-time
This command sets the amount of time the management console is
inaccessible after the number of unsuccessful logon attempts exceeds the
threshold set by the
command. Use the
no
form to
remove the silent time value.
Summary of Contents for SSE-G2252
