Chapter 37: Class of Service Commands
Priority Commands (Layer 2)
– 1123 –
E
XAMPLE
The following example sets the queue mode to strict priority service mode:
Console(config)#queue mode strict
Console(config)#
R
ELATED
C
OMMANDS
queue weight
This command assigns weights to the four class of service (CoS) priority
queues when using weighted queuing, or one of the queuing modes that
use a combination of strict and weighted queuing. Use the
no
form to
restore the default weights.
S
YNTAX
queue weight
weight0...weight3
no
queue weight
weight0...weight3
- The ratio of weights for queues 0 - 3
determines the weights used by the WRR scheduler. (Range: 1-255)
D
EFAULT
S
ETTING
Weights 1, 2, 4, 6 are assigned to queues 0 - 3 respectively.
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
•
This command shares bandwidth at the egress port by defining
scheduling weights for Weighted Round-Robin, or for the queuing mode
that uses a combination of strict and weighted queuing (
).
•
Bandwidth is allocated to each queue by calculating a precise number
of bytes per second that will be serviced on each round.
E
XAMPLE
The following example shows how to assign round-robin weights of 1 - 4 to
the CoS priority queues 0 - 3.
Console(config)#queue weight 1 2 3 4
Console(config)#
R
ELATED
C
OMMANDS
Summary of Contents for SSE-G2252
