Supermicro SSE-G2252, User Manual

Page: 1055 / 1401

Chapter 35: ERPS Commands
– 1068 –
E
XAMPLE
Console(config-erps)#rpl neighbor
Console(config-erps)#
rpl owner
This command configures a ring node to be the Ring Protection Link (RPL)
owner. Use the no form to restore the default setting.
S
YNTAX
rpl owner
no rpl
D
EFAULT
S
ETTING
None (that is, neither owner nor neighbor)
C
OMMAND
M
ODE
ERPS Configuration
C
OMMAND
U
SAGE
• Only one RPL owner can be configured on a ring. The owner blocks
traffic on the RPL during Idle state, and unblocks it during Protection
state (that is, when a signal fault is detected on the ring or the
protection state is enabled with the erps forced-switch or erps manual-
switch command).
• The east and west connections to the ring must be specified for all ring
nodes using the ring-port command. When this switch is configured as
the RPL owner, the west ring port is automatically set as being
connected to the RPL.
E
XAMPLE
Console(config-erps)#rpl owner
Console(config-erps)#
version
This command specifies compatibility with ERPS version 1 or 2.
S
YNTAX
version {1 | 2}
1 - ERPS version 1 based on ITU-T G.8032/Y.1344.
2 - ERPS version 2 based on ITU-T G.8032/Y.1344 Version 2.
D
EFAULT
S
ETTING
2
C
OMMAND
M
ODE
ERPS Configuration