Chapter 35: ERPS Commands
– 1066 –
Figure 35-3: Sub-ring without Virtual Channel
E
XAMPLE
Console(config-erps)#raps-without-vc
Console(config-erps)#
ring-port
This command configures a node’s connection to the ring through the east
or west interface. Use the
no
form to disassociate a node from the ring.
S
YNTAX
ring-port
{
east
|
west
}
interface
interface
east
- Connects to next ring node to the east.
west
- Connects to next ring node to the west.
interface
ethernet
unit
/
port
unit
- Unit identifier. (Range: 1)
port
- Port number. (Range: 1-12)
port-channel
channel-id
(Range: 1-12)
D
EFAULT
S
ETTING
Not associated
C
OMMAND
M
ODE
ERPS Configuration
C
OMMAND
U
SAGE
•
Each node must be connected to two neighbors on the ring. For
convenience, the ports connected are referred to as east and west
ports. Alternatively, the closest neighbor to the east should be the next
node in the ring in a clockwise direction, and the closest neighbor to the
west should be the next node in the ring in a counter-clockwise
direction.
•
Note that a ring port cannot be configured as a member of a spanning
tree, a dynamic trunk, or a static trunk.
Sub-ring
with Virtual
Channel
RPL Port
Interconnection Node
Ring Node
Major Ring
Summary of Contents for SSE-G2252
