Supermicro SC216A-R900LPB, User Manual

Page: 55 / 169

5-13
Chapter 5: Chassis Setup and Maintenance
This U model chassis is
pictured without the riser card
bracket.
Shield Clamp for
Full-Height Card
Shield Clamp for
Low Profile Card
Figure 5-12. Remove an Expansion Card Slot Shield
5. For a full-height extension card, release the clamp that secures all four PCI
shields. Looking at the rear of the chassis, this clamp is in the right corner.
Unscrew the single screw that secures the clamp and rotate the clamp away
from the shields.
For a low profile extension card, release the box-shaped clamp that secures
all three PCI shields. Looking at the rear of the chassis, this clamp is near the
middle, just left of the low profile PCI slots. Unscrew the single screw that se -
cures the clamp and slide the clamp to the left away from the shields.
6. Insert the expansion card into a slot on the riser card while aligning the
expansion card backplate with the open slot in the rear of the chassis. Repeat
for other expansion cards if you are installing more than one.
7. Secure the card backplates to the chassis by returning the clamp to the
closed position and installing the locking screw.
8. Replace the chassis cover and power up.