Page 7
CHAPTER 2: POWER SUPPLY
1. Installation: Hot-Swap procedures
Please refer to the following procedures should either one of your power supply units is found
defective.
A)
Locate the defective power supply by examining the individual LED on the module, or the LED on the
system front panel.
B)
Unscrew the defective power supply unit.
C)
Remove the defective power supply unit.
D)
Replace a bad unit with a new GOOD power supply unit by inserting a new power supply into the power
supply system.
E.)
Check the DC OK LED-- the power supply status indicator. There are two DC OK LED Indicators, one
indicator for each power supply unit. If a power supply unit functions correctly, its indicator should light
up. If the indicator does not light up, then you need to fix the power supply unit.
