5013C-M8
HD
4 Hot-swap SCSI drive bays
Heatsink Installation
Caution!
Do not apply any thermal grease to the heatsink; the
required amount of thermal grease has already been
applied.
1) Only those CPU heatsinks that are provided by Supermicro
should be used.
2) Do not apply any thermal grease to the heatsink - the required
amount has already been applied.
3) Place the heatsink on top of the CPU so that the four mounting
holes are aligned with those on the chassis.
4) Screw in two diagonal screws (ie. the #1 and #2 screws) until
just snug (do not fully tighten), then do the same with the
remaining two diagonal screws.
5) Finish by fully tightening all four screws.
Front side 2 USB & 1 COM port
10
2. CD-ROM drive
LBL-0119
REV 1.0
No.3 Screw
No.2 Screw
No.4 Screw
No.1 Screw
9. Reset button
10. Power button
SNK-P0002
