Chapter 4: BIOS
4-15
Remote Access Confi guration
Remote Access
Allows you to
Enable
or Disable remote access. If enabled, the settings below
will appear.
Serial Port Number
Selects the serial port to use for console redirection. Options are COM1, COM2
and
COM3
.
Serial Port Mode
Selects the serial port settings to use. Options are
(115200 8, n, 1)
, (57600 8,
n, 1), (38400 8, n, 1), (19200 8, n, 1) and (09600 8, n, 1).
Flow Control
Selects the fl ow control to be used for console redirection. Options are
None,
Hardware and Software.
Redirection After BIOS POST
Options are Disable (no redirection after BIOS POST), Boot Loader (redirection
during POST and during boot loader) and
Always
(redirection always active).
Note that some OS's may not work with this set to Always.
Terminal Type
Selects the type of the target terminal. Options are ANSI,
VT100
and
VT-UTF8.
VT-UTF8 Combo Key Support
Allows you to
Enable
or Disable VT-UTF8 combination key support for ANSI/
VT100 terminals.
Sredir Memory Display Delay
Use this setting to set the delay in seconds to display memory information.
Options are
No Delay
, 1 sec, 2 secs and 4 secs.
Summary of Contents for MNL-H8DI3+
