Supermicro AOC-A25G-b2S, User Manual

Page: 19 / 32

Chapter 2: Hardware Components
2-7
2-4 Jumper Settings
Explanation of Jumpers
To modify the operation of the motherboard, jumpers can be used to choose between
optional settings. Jumpers create shorts between two pins to change the function of
the connector. Pin 1 is identified with a square solder pad on the printed circuit board.
AOC JPAUX1 set
to Disabled
When system/MB goes into a standby mode
IPMI Support FailOver Support WoL Support
No No No
When system/MB is NOT in the standby mode
IPMI Support FailOver Support WoL Support
Yes Yes N/A
AOC JPAUX1 set
to Enabled
When system/MB goes into a standby mode
IPMI Support FailOver Support WoL Support
Yes Yes Yes
When system/MB is NOT in the standby mode
IPMI Support FailOver Support WoL Support
Yes Yes N/A
JPAUX1 for
Standby
Power
Function Notes
Disable = No
standby power
to AOC NIC Disable jumper
to disconnect the
standby power Default
Enable =
Standby power
to AOC NIC Enable jumper to
connect standby
power to AOC NIC WoL is supported on all four ports
but limited to platforms with sufficient
airflow when it is in standby mode
(S5 state). Please consult Supermicro
before enabling it.