9
Installation Instructions
STEP 11 SECURE DISHWASHER
TO THE COUNTERTOP
IMPORTANT
–
Drive screws
straight and flush. Protruding screw heads will
scratch the top of the control panel and can
interfere with door closing.If the gap is less than
STEP 12 CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
· Slide compression nut, then ferrule over end of
water line.
· Insert water line into 90° elbow.
· Slide ferrule against elbow and secure with
compression nut.
IMPORTANT
–
Check to be sure
that door spring does not rub or contact the fill hose or
water supply line. Test by opening and closing the door.
Re-route the lines if a rubbing noise or interference
occurs.
Ferrule
90
°
Elbow
Compression Nut
Hot Water
Supply Line
For countertops made of wood or that will not
be damaged by drilling,use Method 1.
For countertops made of granite,marble,or
other materials that could be damadged by
drilling,use Method 2.
METHOD 1
1. Use longer brackets.
2. Insert the installation brackets into the slot.
3. Bend the brackets to secure them to the
dishwasher tub.
4. Using the provided screws,secure the
dishwasher to the countertop through the
holes in the bracket.
METHOD 2
1. Open the door remove the tub cap on both sides
of the tub.
2. Driver a wood screw through the dishwasher side
holet and into the cabinet frame.
3. Reinstall the plastic caps.
Installation
bracket
Screw
Screw
Cap
10mm between control panel and the screws ,
hole
suggest to chose method 2 .
