SuperiorFireplaces.us.com
900463-01A
25
REMOTE READY MODELS
OPERATION
Continued
TO TURN OFF GAS
TO APPLIANCE
1. Turn control knob clockwise
to the
OFF position.
2a. Set switch in the OFF position.
2b.
If Using Optional Hand-Held Remote:
Set selector switch in the OFF position to
prevent draining battery.
3. Close equipment shutoff valve
(see Fig-
ure 15, Page 15).
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Lighting
Instructions
,
Page 23
.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30
seconds after lighting pilot. After 30 sec-
onds, release control knob. Now follow
steps 9 through 11,
Lighting Instructions
,
Page 23
.
OPTIONAL HAND-HELD
REMOTE OPERATION
NOTE: All remote control accessories must
be purchased separately (see Accessories,
Page 41). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on Page 23.
After lighting, let pilot fl ame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust fl ame adjustment knob anywhere
between HI and LO. Slide the selector switch
to the REMOTE position
(see Figure 37).
Figure 37 - Control Knob, Igniter Button
and Remote Selector Switch
Selector
Switch
Control
Knob in OFF
Position
Flame
Adjustment
Knob
Igniter
NOTE: The burner may light if hand-held
remote was on when selector switch was last
turned off. You can now turn burner on and off
with hand-held remote control unit.
IMPORTANT:
Do not leave selector switch in
the REMOTE or ON position when pilot is not
lit. This will drain the battery.
NOTE: Do not hold hand-held remote for a
long time. Body temperature will affect its
operation in the AUTO mode.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fi re or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the fl oor because some
gas is heavier than air and will settle
on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fi re department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don’t try to repair it, call a quali-
fi ed service technician or gas supplier.
Force or attempted repair may result in
a fi re or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualifi ed service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
VARIABLE REMOTE
MODELS OPERATION
