51
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation and Operation Instructions
900300-00, 02/2015
Innovative Hearth Products
Superior
TM
DRT35 See Through and Peninsula Direct Vent Gas Fireplace
Front Glass Enclosure Panel, Removal
and Installation
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l’entretien de
l’appareil doit être remis en
place avant de mettre l’appareil
en marche.
WARNING
• Do not attempt to substitute the
materials used on this door, or
replace cracked or broken glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
• The glass door(s) of this appli-
ance must only be replaced as a
complete unit as provided by the
manufacturer. Do not attempt
to replace broken, cracked or
chipped glass separately.
• Do not attempt to touch the front
enclosure glass with your hands
while the fireplace is in use.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
CAUTION: DO NOT abuse glass door by
striking or slamming shut.
These are direct-vent appliances. They are
designed to operate only when the front glass
enclosure panels are installed. Generally the
front glass enclosure panel should not be re-
moved except to gain access to the components
within the firebox.
Figure 76
Glass Door Latch
Lower Compartment Door and Hinge
Glass Door
Firebox Floor
Bottom Vee-flange
Glass Door Frame
Top Flange
Glass Door Frame
INSTALL VERMICULITE, GLOWING EM-
BERS AND LOGS
NOTE: Turn off all electricity to the appliance
before you install vermiculite, embers and logs.
DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
To access the glass door securing latches, first re-
move the hood by pulling firmly straight away from
the unit. Remove the front face assembly by lifting
up top and bottom evenly approximately 1/2" and
pulling straight out from the unit once the brackets
are disengaged.
Remove the bottom compartment door by sliding
the hinge pin, located at the door’s left
side, to the right until it disengages from the left
corner post hole. Pull the door diagonally to the left,
away from the fireplace. Locate the latch at the top
of the control compartment and disengage them
from the door frame bottom vee-flange, pulling
down on its handle to open it.
Installing Glass Enclosure Panel (see Figure
76)
Retrieve the glass door. Visually inspect the gasket
on the backside of the frame. Gasket
surface must be clean, free of irregularities and
seated firmly.
Position the door in front of the firebox opening
with the bottom of the door held away from the
fireplace (
Figure 76
). Hook the top flange of the
door frame over the top of the firebox frame.
Let the bottom of the door frame swing gently in
towards the fireplace ensuring that the gasket seats
evenly as the door frame draws shut. Fasten the
latch located underneath the firebox floor to the
door's vee-flange. Close both the latch securely.
NOTE: Front Face Assembly with
barrier installed must be reinstalled
prior to operation.
