Superior 017821, User Manual And Parts List, Page: 21 / 30

Programming a Replacement Remote
If you lost your remote and need to program a replacement, you can do it yourself. You
will need to order
part number D-13535. Once you receive your replacement
remote, use a 4mm Allen key to remove (6) M5 socket
head cap screws on the bottom plate as shown. Lift
off the bottom plate to access the internal cavity of
the Magvibe™ Pro. The plate may resist a bit
due to the gasket sealer.
Once you are inside
of the cavity,
locate the RF /
Motor controller
board. The
button indicated
by the red arrow is
P1 and it will be used
for the programming of
channel 1. Press and hold P1 for at least
1 second; the LED on the board will light for 1 second, go
off for 1 second, and then light again.
Press and hold the A button on the remote control. If the code is
successfully received; the LED will blink, and you can release the A
button. If the code is unsuccessful; the LED will light for 10
seconds as it finishes the learning cycle.