3
SECTION 3: INSTALLATION GUIDELINES
3.1 MOUNTING
ELTERM 24 Operator Interface Terminal
The terminal is mounted by inserting it into a panel cutout then using the sup-
plied mounting brackets and gasket to keep it in place.
Figure 3.1a, ELTERM 24 Mounting Diagram
When selecting a mounting location, it is important to leave at least two inches
(51mm) of space around the top, bottom and sides of the unit to allow proper
airflow for cooling. Refer to cutout diagram below.
It is also important to keep the terminal away from obvious sources of electrical
noise. If possible, locate it in its own metal enclosure to shield it and its wiring
from electrical noise sources. If this cannot be done, keep it at least three feet
from any noise sources.
StockCheck.com
