7
SENS Button: choose in five levels with SENS “+”or “-” button. Boot setting is in the middle
value (the third level).The highest sensitivity is the fifth level, when there is interference
existent; you can adjust the sensitivity lower properly.
DISCRIM Button: in the two modes of CUSTOM and DISCRIM, the operator can choose
the type of “eliminate” metals according to DISCRIM “+”or “-”button.
ELIM Button: in the CUSTOM mode, cooperate with DISCRIM button to eliminate the type
of metals.
PINPOINT Button: press and hold down the “PINPOINT” button, the detector converts into
the non-motion mode, and it no longer has discrimination ability. At this time, the PINPOINT
cursor is lighted, the upper Target ID cursor is useless, and the lower cursor Target
Discrimination cursor turns into signal strength cursor. The more close to the metal target, the
lower strength cursor is lighted more scale, and the sound is louder, you can locate the target
location accurately.
GROUND BALANCE Button: it’s used in the PINPOINT mode. In general, set it RESET. In
the serious soil salinity environment, adjusting the ground balance, when the search coil of
the detector approaches the ground, it will not sound a tone.
QUICK START
1.
Prepare with the four metal samples
an iron nail
a 5
¢
nickel coin
a 1
¢
zinc coin(after 82 version)
a 25
¢
silver coin
2.
Lay the detector
Place the detector on a wooden or plastic table, let the search coil exceeds the table edge
about more than 30cm.keep the detector away from the wall, ceiling and floor, turn off all the
equipment which can cause electro-magnetic interference. Please take off the watch, ring or other
metal objects on your hand or arm. (See Figure.10).
Fig10