If you have any questions during the setup process, please call a SuperCloset representative at 1.877.476.9787
1.
Locate your Yo-Yo light hangers (image a).
2.
Loop the carabiner end over the top support of the tent and clip it to itself
(image b). To adjust height, pull on the lose string to raise the Yo-Yo or
press the button on the side of the Yo-Yo hanger to lower.
3.
Unpack your T5 grow light(s).
4.
Place the T5 Light(s) in the bottom of the tent. Lower the Yo-Yo system
until you can connect the the Yo-Yos to the T5 hanging hardware. Raise
the light to the desired height using the loose end of the Yo-Yo hanger
cord.
5.
Run the power cord from the light through the nearest electrical port hole.
Hanging your T5 Light
1.
Locate the Thermometer/Hydrometer (image c). Remove the battery cover
and remove the plastic safety blocker from the battery terminal. You can
be creative on where you would like this placed inside the tent, but the
easiest placement is inside the tool pouch on the inside of the tent.
2.
Run the external probe to the outside of the tent, through the nearest
ducting port. Make sure the probe is not touching any surface on the
outside of the tent as this will provide false readings.
3.
Locate the Clip-On Active Air Fan (image d). Clip the fan to any one of the
inside corner vertical poles. The fan is designed to provide circulation and
air movement.
Thermometer/Hydrometer/ICF
1.
Locate the clone rack(s). Unbox, assemble and place in your Clone Room
Clone Rack
a
b
c
d
e
