Underwater LED Boat Light
WIFI-CON
User Manual
Part Number:
Important: Read all instructions prior to installation.
UBL-x60
Features
Parts Included
Recommended Tools (not included)
Caution
Specifications
316L Marine Grade Stainless Steel
Poly-Carbonate Lens
5 Ft Power Wire (18AWG)
Internal Driver
Over-Temp Protection
Waterproof IP68
Underwater Boat Light
1- (UBL-x60)
2- M5 Machine screws
2- M5 Flat washers
2 - M5 Locking Nuts
2 - M5 Self Tapping screws
2- Neoprene washers
Drill and Drill Bits
#2 Phillips Screwdriver
Heavy Grit Sandpaper
Pencil
(Wax Pencil recommended for fiberglass)
Isopropyl/Denatured Alcohol
Lint Free Cloths
Masking Tape
Marine Sealant
LIGHTS MUST BE SUBMERGED TO AVOID OVERHEATING.
USE OUT OF WATER WILL DECREASE LED LIFETIME AND CAUSE EARLY
FAILURE.
LIGHTS HAVE OVER TEMPERATURE PROTECTION (FOR TESTING
PURPOSES ONLY) AND WILL SHUT OFF WHEN MAX TEMP (194 F / 90 C)IS
REACHED.
DO NOT OPERATE LIGHTS OUT OF WATER FOR MORE THAN 2 MINUTES
FOR TESTING.
LIGHTS WILL BE HOT IF OPERATED OUT OF WATER FOR EXTENDED
PERIODS.
INSTALLATION OF LIGHTS MUST BE DONE WHILE BOAT IS OUT OF WATER
AND DRY.
SBL IS NOT RESPONSIBLE FOR ANY INJURY OR PROPERTY DAMAGE
INCURRED DUE TO IMPROPER INSTALLATION.
Installation Instructions
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533 superbrightleds.com
60W LED Underwater Boat Light
Input Voltage
9 ~ 32 VDC
Current Draw
2.8 A @ 13.5VDC
Total Power Consumption
37.8W @ 13.5VDC
Operating Temperature
-22°F~122°F (-30°C~50°C)
Available Colors
Red, Green, Blue, White
LED Lifetime
50,000 Hours
Warranty
3 Years
Dimensions
Dia. ø 3.69in (9.4cm),
Thickness 0.67in (1.7cm )
Weight
1.43 lb (0.65kg)
TIP: Know your hull; most common type is fiberglass.
Wood, metal and carbon fiber are other less common hull types.
For metal or carbon fiber hull, first be sure to mount an insulating
material between metal or carbon fiber surfaces and lights to
prevent galvanic corrosion.
If uncertain about type of hull, please contact boat manufacturer
for assistance.
1. Determine desired mounting location on boat’s transom.
Water Line (at idle)
Water Line (at speed)
RS-X
Butt Connector
(PSC-1210)
Fuse Holder (WMFH)
Fuse (MAF-x)
Black (-)
Red (+)
Battery
UBL-x60
Overheat
OK
Water Line (at idle)
Water Line (at speed)
OK
OK
Be sure to check actual draft water level if operating LED
lights at speed. (See Diagram Below)
Recommended mounting depth between 6-8” below
waterline for best effect. Be sure that mounting location is
free of any obstructions before drilling through hole. Mark
center of desired location.
