WIFI-CON
User Manual
Important: Read all instructions prior to installation.
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533 superbrightleds.com
Pole Mount Installation
1. Remove supply power.
2. Make all electrical connections.
3. Loosely attach pole mount bracket to light.
4.
Slide light over pole (max diameter 1.75” OD) and tighten mount bracket.
Note: Overtightening bracket may result in damage to pole or bracket.
5. Restore supply power.
6.
Remove cap and adjust wattage and CCT to desired value. Replace cap to prevent damage to switch.
Wall Mount Installation
1. Remove supply power.
2.
Measure mounting flange and drill three pilot holes.
3. Partially thread the bottom two lag screws in place.
4. Place light over to lower lag screws and install third lag screw, then tighten all lag screws.
5. Make all electrical connections. Wire should pass through rear or lower access plate knockout
using conduit.
6. Attach access plate to light.
7.
Restore supply power.
8.
Remove cap and adjust wattage and CCT to desired value. Replace cap to prevent damage to switch.
Field-Selectable Wattage and CCT LED
Dusk-to-Dawn Area Light
DDAL-SW3Bx
Rev Date: V1 11/01/2021
10#
.30in
7.62mm
2.65in
67.31mm
2.46in
62.43mm
2.17in
55.12mm
ON
Wattage Selection
Photocell
CCT Selection
100%
80%
OFF
ON
5000K
4000K
3000K
60%
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
10#
.30in
7.62mm
2.65in
67.31mm
2.46in
62.43mm
2.17in
55.12mm
ON
Wattage Selection
Photocell
CCT Selection
100%
80%
OFF
ON
5000K
4000K
3000K
60%
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
ON
1 2
4 5
