Page 17
15. ELEVATOR
– Unfolding procedure
Folding Procedure is a reversal of these steps
.
1. Extend stabilizer leg and adjust wheel to
suit ground level.
2. Loosen cable 3-4 turns and hook into eye
in centre hinge joint in elevator.
3. Pull out to a vertical position. Elevator will
now be supported by winch cable.
4. Lower elevator so roller is on the ground.
5. Roll top section out and lower elevator to
unfolded position with winch.
6. Unhook cable from centre position and re-
hook onto end position. Lift elevator to
horizontal position
7. Remove long pin from under chain and
replace on top of chain.
8. Remove roller from end and using the
same long pin, attach rubber flap to lower
end. Winch up to operating height.
NOTE check position of cleats before folding
–
See instructions Page 16 (1)
