6Superabrasive
User Manual Original Language
Lavina® 20GE
7/2020
23
4.9 OPERATING THE MACHINE
Guide the machine in straight lines across the floor, slightly overlapping the previously completed surface with each new line.
Work at a constant speed, allowing the tools time to work at a speed appropriate for the tools’ grit size. Avoid vibrations. Do not
stop the machine while tools are still running as they will mark the surface of the floor. When working wet, select the destination
of the water feed with the water tap (fig. 4.2-1) and periodically run the pump to release water onto the floor surface. Starting the
pump is possible only if the machine motor is on. When working dry, check the floor surface periodically for dust accumulation.
Check regularly to see if you’re vacuum works properly.
4.10 STOPPING THE MACHINE
The stopping of the machine must be done gradually until the motor stops. Do not stop moving the machine before the
motor comes to rest, as the tools could damage the surface. To stop, push the Stop clutch rocker (2), then close (clockwise)
the service valve on the propane tank. ALWAYS allow the engine to run until it stops from lack of fuel.
• In case of emergency ONLY press the "stop" position on the Start/Stop Engine switch (1) and disconnect the fuel line from
the tank.
When finished with the machine, store the propane tank outside the building, in a
SECURE
place away from heat or direct
sunlight.
