04 SUPERHERO STEAM MOP
Assembly and use for model BS-390
1. Assembly
a.
Remove all the parts from the packaging.
b.
Insert the upper extension tube into the middle
& lower extension tubes.
See fi g. 1
Push it in until you hear it click into place.
c.
Insert the extension tube assembly into the
main mop connector. Make sure that the
locking tab snaps into place.
d.
Place the micro-fi bre cleaning pad underneath
the mop head. Make sure that the hook and
latch strips are facing up.
See fi g. 2
Press to secure.
2. Filling the Water Tank
IMPORTANT:
Always ensure that the unit is
“UNPLUGGED” from the mains power prior to
initial fi lling and before attaching the micro-fi bre
cleaning pad to the bottom of the mop head.
Never use the steam mop without the micro-fi bre
cleaning pad attached to the mop head.
a.
Lift water fi ll cap to fi ll water into the water tank.
See fi g. 3.
b.
Using the measuring cup and funnel, pour one
fl ask of water into the water tank.
Do not
overfi ll
the unit.
c.
Replace the cap onto the water fi ll point.
3. Using the Steam Mop
IMPORTANT:
Never use the steam mop without
the micro-fi bre cleaning pad attached to the mop
head or without water in the water tank.
1.
Sweep or vacuum fl oors before using the
steam mop.
2.
Unwrap the power cable from the rear power
cord placement hooks completely.
3.
Plug into mains power.
4.
When plugged in, the LED light will turn red.
Press down the on/off switch, the heating up
light will turn green.
5.
It takes approximately 30 seconds for the unit
to heat up and the steam to be ready when the
switch is pressed.
6.
When the water tank is empty, the steam mop
will stop emitting steam. Unplug the power
cable from the mains power and refi ll the water
tank following the instructions above.
7.
When fi nished using the steam mop, unplug
the unit from the mains power and carefully
remove the micro-fi bre cleaning pad from the
mop head. Note that the micro-fi bre cleaning
pad gets very hot with the steam. Always use
caution when removing.
8.
NEVER
leave the micro-fi bre cleaning pad on
the steam mop head when you have fi nished
using the steam mop.
fi g. 2
fi g. 3
fi g. 1
Water fi ll cap