3
Figure 11 – Wireless mode setup
5.
Match the
Security
settings of the Access Point you will connecting to. The default setting is
Open
.
Figure 12 – Security setup default
Options for Personal WPA and Personal WPA2 are available with AES encryption. If you selected one of these, enter the matching
Passphrase.
Figure 13 – Security setup WPA/WPA2
6.
To ensure the transmission power of the wireless device is set correctly for any environment, check the
Enable ATPC
box. This will
automatically adjust the TX power of the device. Leave all other settings at the defaults shown below.
Figure 14 – Advanced setup
7.
Click
Save
&
Apply
at the top right of the screen.
Step 3. Setup the Initial Station
1.
Repeat 1 – 3 from
Step 2
above to log into the wireless device.
2.
Navigate to the
Configuration | Network
tab, then choose the Bridge network mode. Keep the IP method set to Static IP, and enter
the desired network address settings for the Client Station. The IP address must be on the same subnet as the Access Point it will be
connecting to on the wireless network. For example, if the Access Point is set to 192.168.2.66, set the Station to 192.168.2.67.
Figure 9 – Network setup
3.
Navigate to the
Configuration | Wireless
tab, then choose
iPoll Station
from the
Wireless mode
drop down menu.
Figure 10 – Wireless mode setting
4.
If the Access Point is online, you can scan for the SSID of the wireless network by pointing the antenna of the station toward the Access
Point. If the Access Point in not online, manually enter in the SSID of the Access Point that the Station will be connecting to when
deployed. Ensure the
Channel width
setting matches the setting of the Access Point you are connecting to.
