2
www.supercircuits.com
© 2011 Supercircuits, Inc. All rights reserved.
3. Apply the mounting template to the mounting surface. Mark the location of the holes for the
fasteners.
4. Attach the camera to the mounting surface with 4 fasteners.
5. Connect the drop cable BNC connector to a mating connector on a video extension cable. Connect
the other end of the extension cable to a video recorder or monitor.
NOTE
Drop cable video and power connectors are not waterproof.
6. Connect the camera power drop cable to a power extension cable. The polarity of the power drop
cable is shown in the following representation. An adapter for a non-connectorized power source is
provided with the camera.
7. Connect the other end of the power extension cable to a 12 VDC power source. Verify that an image
from the camera appears on the monitor.
Step 2. Camera setup
All setup adjustments are made on the underside of the camera body.
8. While observing video from the
camera, loosen the gimbal set screw
until the camera body can move freely.
9. Point the camera at the center of the
field of view, then tighten the set
screw.
10. Set the Tele-Wide adjustment to fill the
image with the best field of view.
11. Set the focus adjustment to sharpen
the image.
Focus
Tele-Wide
IR LED
Intensity Pot.
IR LED
Working
Time Pot.
Gimbal
Set Screw
12. While viewing a license plate under the darkest conditions, remove the cap on the underside of the
camera. Then:
a. Adjust the IR LED Intensity potentiometer to produce the best image for the normal distance
of the vehicle from the camera. Increase the level for more distant vehicles.
b. Adjust the IR LED Working Time potentiometer for IR use to begin at a specific lighting level.
For example, you can adjust this potentiometer to also use IR during bright conditions, such
as daylight.
c. Reinstall the cap.
Table 1. Specifications
Item
Specification
IP rating
IP66
Filter
Five-layer filter
Image Sensor
1/3” Hi-resolution Color Sony® CCD
Pixels
811 (H) x 508 (V)
Horizontal Resolution
600 TVL
IR LED
80-LED IR array
Vertical frequency
60 Hz
Horizontal Frequency
15.734 KHz
Clock Frequency
28.636 MHz z
Scanning System
2:1 Interlace
S / N Ratio
≥ 50 dB
Electronic Shutter
Fixed
White Balance
Auto tracking
Back Light Compensation
ON
Auto Gain Control
ON
Gamma
0.45
Video Output
1 V p-p, 75Ω
Lens
9 - 22 mm vari-focal auto-Iris lens
Viewing angle
Diagonal: 21° / horizontal: 17° vertical:13°
Power Supply
12 VDC ± 10%
Current Consumption
200mA
Available IR Distance
6.56 ft~ 49.18 ft (2 m~ 15 m)
Dimension
9.92” x 7.30” x 4.13” (252 mm x 185.5 mm x 105 mm)
Weight
4.32 lbs (1960 g)
Storage Temperature
-22
°
F ~ +140
°
F (-30
°
C ~ +60
°
C)
Operating Temperature
-22
°
F ~ +104
°
F (-30
°
C ~ +40
°
C)
Capture the license plate
Up to vehicles traveling at the speed of 30 mph
