\
GROUND
I
I
I
SWITCH OUT
- - _- -
Set the MULTIPLEXER option to ON on the REC Setting
page in the setup menu.
Configure the connected multiplexer recording mode
to match programmed recording speed of DVR if the
SWITCH OUT terminal of the DVR is not connected
to the multiplexer's trigger contact.
Audio function can only be activated in the following
refresh rate (NTSC
/
PAL): 20(17), 12(1
0
), 5.5(5.5),
2.4(2.9), 1.22(1.52), 0.71 (0.88) fieldslsec
*
ETHERNET port is for network model only.
,
QUAD
Set the MULTIPLEXER option to OFF on the REC Setting
page in the setup menu.
Audio function can only be activated in the following refresh
rate (NTSCIPAL): 20(17), 12(1
0
), 5.5(5.5), 2.4(2.9), 1.22(1.52),
0.71 (0.88) fieldslsec
(
CONNECT WlTH A QUAD )
Monitor
(
CONNECT WlTH A SINGLE CAMERA )
ETHERNET port is for network model only.
* This function is for network model only.
Connect the DVR to your
network with a 1011 00m base
Ethernet data cable (Standard RJ-45).
You don't need to set an IP address for the DVR if the LAN which
the unit is connected to has a DHCP server. Otherwise, assign an
IP address for the DVR through COMM SETTING page.
Set the NET ENABLE to ON on the COMM SETTING page in the
setup menu.
Install the Network Viewer to your computer.
Open the Network Viewer from the Start menu of your computer.
Enter the IP address and password.
