background image

4400 Earth City Expy, St. Louis MO 63045 

866-590-3533                [email protected]

Care and Maintenance:

 To clean, unplug lamp and wipe with a damp, non-abrasive cloth.

Troubleshooting

Warranty

Warning

PROBLEM

LED light will not turn on

LED light flickers

POSSIBLE CAUSE

1.  No power.

2.  Loose wire to the connector

3.  Connector not making contact with  

 

primary cable.

4.  Power pack/transformer’s photo  
 

cell sensor is exposed to unwanted  

 

light source.

1.  Wattage of power pack/transformer  
 

may be exceeded.

CORRECTION ACTION

1.  Wattage of power pack/transformer may be  
 

exceeded.

2.  Make sure brass contact pins pierce the plastic  
 

wire insulation and are touching the copper  

 

wires inside.

3.  Make sure cover is tight. If problem persists,  

 

repeat steps 3 to 6 on the instructions.

4.  Make sure that power pack/transformer’s photo  
 

cell sensor is not exposed to lights.

1.  Check manufacturer’s specification for    
 

maximum wattage.

The manufacturer warrants all of its products against defects in materials and workmanship for three (3) years from the date of purchase. 
If within this period the product is found to be defective in material or workmanship, please contact the manufacturer, a copy of the 

original sales receipt will be required as proof of purchase. The manufacturer will, at its option, repair or replace the product. This 

warranty does not cover products becoming defective due to misuse, accidental damage, improper handling and/or installation and 
specifically excludes liability for direct, incidental or consequential damages. As some states do not allow exclusions or limitations on an 
implied warranty, the above exclusions and limitations may not apply to you. This warranty gives you specific legal rights, and you may 
have other rights that vary from state to state.

• 

Risk of fire or electrical shock. Read all of these 
instructions thoroughly before use. Keep this instruction 

manual in a safe place for future reference.

•  Do not install or connect wires with wet bands.
• 

Do not install this product within 10 ft. from a pool, spa, 
fountain, or other body of water.

• 

The fixture wire and primary cables are intended for 
shallow burial - maximum depth must not exceed 3 in.

• 

For low-voltage landscape lighting systems only.

•  Do not step on or drive over the branch cable or power 

cable.

Caution

• 

This lighting fixture is only suitable for a 12~15volt 
power supply.

• 

This LED lamp is a highly efficient, extremely low 
wattage, energy-saving product. However, it is not 

recommended to use a power pack/transformer over 

100 watts.

• 

Use shielded cable for outdoor use in the following 
sizes: 18G, 16G, 14G, 12G.

•  Do not submerge in water.
• 

Do not repair or modify this product.

Reviews: